AMX MAX-HT12T Manuál s instrukcemi stáhnout pdf (Strana 53)

MXD-430 4.3” X Series Wall/Flush Mount Touch Panel

MXD/T-1000, MXD/T-700 and MXD-430 Modero X Series® Touch Panels

Apply enough pressure to the screw head to keep the box flush with the wall: this ensures that the locking tabs

will tighten up against the inside of the wall.

The Backbox is clear to allow visual confirmation that the tabs have been extended and are gripping the wall,

as well as in assisting with removal if necessary.

For additional strength, #4 mounting screws (not included) may be secured through circular holes located at

the top and bottom of the MXD-430 (FIG. 44). In order to prevent damage to the touch panel, make sure that

these are flush with the Backbox.

9. Insert each connector into its corresponding location along the back of the device (FIG. 40).

Test the incoming wiring by attaching the panel connections to their terminal locations and applying power.

Verify that the panel is receiving power and functioning properly to prevent repetition of the installation.

Remove power before continuing with the installation.

10. Latch the panel onto the bottom hooks on the Backbox and push it up onto the top snap (FIG. 46). Press gently but

firmly on the ends until the snap “clicks” to lock it down.

FIG. 45 MXD-430 Backbox installed in wall

Locking Tab screws

Do not disconnect the cables from the touch panel. The unit must be installed with the

attached connectors before being inserted into the mounting surface.

1 2 ... 48 49 50 51 52 53 54 55 56 57 58 ... 61 62

Žádné komentáře

AMX MAX-HT12T Manuál s instrukcemi Strana 53