AMX Rack Rail Kit MMS Servers Uživatelský manuál stáhnout pdf (Strana 39)

Chapter 5: Advanced Serverboard Setup

5-3

Heatsink Installation

1. Do not apply any thermal com-

pound to the heatsink or the CPU

die; the required amount has al-

ready been applied.

2. Place the heatsink on top of the

CPU so that the four mounting

holes are aligned with those on the

retention mechanism.

3. Screw in two diagonal screws (ie

the #1 and the #2 screws) until just

snug (-do not fully tighten the

screws to avoid possible damage to

the CPU.)

4. Finish the installation by fully

tightening all four screws.

Figure 5-1. 604-pin PGA Socket: Empty and with Processor Installed

Warning! Make sure you lift the lever completely when

installing the CPU. If the lever is only partly raised, damage

to the socket or CPU may result.

Lever

With processor installed

Triangle (pin 1)

Empty socket

Triangle locating pin 1

Screw #1

Screw

1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 125 126

Žádné komentáře

AMX Rack Rail Kit MMS Servers Uživatelský manuál Strana 39