AMX Distributed Audio Controllers Delta Series Specifikace stáhnout pdf (Strana 154)

Chapter 5 Parameters|VFD-B Series

Revision July 2008, BE16, SW V4.08 & V5.00 5-97

10 - 03 Integral Gain ( I ) Unit: 0.01

Settings 0.00 to 100.00 sec Factory Setting: 1.00

0.00 Disable

 This parameter specifies integral control (continual sum of the deviation) and associated gain

(I). When the integral gain is set to 1 and the deviation is fixed, the output is equal to the input

(deviation) once the integral time setting is attained.

NOTE

The parameter can be set during operation for easy tuning.

10 - 04 Derivative Control (D) Unit: 0.01

Settings 0.00 to 1.00 sec Factory Setting: 0.00

 This parameter specifies derivative control (rate of change of the input) and associated gain

(D). With this parameter set to 1, the PID output is equal to differential time x (present

deviation − previous deviation). It increases the response speed but it may cause over-

compensation.

NOTE

The parameter can be set during operation for easy tuning.

10 - 05 Upper Bound for Integral Control Unit: 1

Settings 00 to 100 % Factory Setting: 100

 This parameter defines an upper bound or limit for the integral gain (I) and therefore limits the

Master Frequency.

 The formula is: Integral upper bound = Maximum Output Frequency (Pr.01-00) x (Pr.10-05).

This parameter can limit the Maximum Output Frequency.

10 - 06 Primary Delay Filter Time Unit: 0.1

Settings 0.0 to 2.5 sec Factory Setting: 0.0

 To avoid amplification of measurement noise in the controller output, a derivative digital filter is

inserted. This filter helps to dampen oscillations.

The complete PID diagram is shown on the following page:

1 2 ... 149 150 151 152 153 154 155 156 157 158 159 ... 238 239

Žádné komentáře

AMX Distributed Audio Controllers Delta Series Specifikace Strana 154