AMX Distributed Audio Controllers Delta Series Specifikace stáhnout pdf (Strana 115)

Chapter 5 Parameters|VFD-B Series

5-58 Revision July 2008, BE16, SW V4.08 & V5.00

 This parameter is to delay the signals on digital input terminals. 1 unit is 2 msec, 2 units are 4

msec, etc. The delay time is used to debounce noisy signals that could cause the digital

terminals to malfunction.

04 - 23 Gear Ratio for Simple Index Function Unit: 1

Settings 4 ~ 1000 Factory Setting: 200

04 - 24 Index Angle for Simple Index Function Unit: 0.1

Settings

0.0 ~360.0°

Factory Setting: 180.0

04 - 25 Deceleration Time for Simple Index Function Unit: 0.01

Settings 0.00 ~100.00 sec Factory Setting: 0.00

 The simple index function is used to position the machine/motor at the same position when it

stops. The function should be used with setting 34 for Multi-Function Input Terminals (04-04 to

04-09).

 The function diagram is shown below. The machine is driven by a gear motor or other

reduction gearbox. The trigger position of the proximity sensor is used as the starting point of

the index angle. When the stop command is initiated, the AC motor drive will not decelerate

until the proximity sensor is triggered. After that the AC motor drive begins to decelerate and

stop according to the Pr.04-24 and Pr.04-25.

time between STOP and triggering by proximity

sensor. It depends on the moment the STOP

command is given.

Frequency

Proximity Sensor Actives

Time

Signal of Zero

=Pr.04-25

1 2 ... 110 111 112 113 114 115 116 117 118 119 120 ... 238 239

Žádné komentáře

AMX Distributed Audio Controllers Delta Series Specifikace Strana 115