AMX NXI Specifikace stáhnout pdf (Strana 23)

Programming

NXI NetLinx Integrated Controller (No Master)

IR/Serial Send_Commands (Cont.)

POF Turns off a device, based on input Link.

• If at any time the IR sensor reads that the device is on (such as if one turned it on manually at

the front panel), the card automatically attempts to turn the device back off.

• If three attempts fail, the card will continue executing commands in the buffer.

• If there are no commands in the buffer, the card will continue to try until a 'PON' or 'POD'

command is received. If it fails to turn the device off, a PUSH and RELEASE is made on

channel 254 to indicate a power failure error.

• Channel 255 changes are disabled after receipt of this command.

• You can only use the PON and POF commands when an IR device has a linked I/O channel.

Syntax:

SEND_COMMAND <DEV>,'POF'

Example:

SEND_COMMAND IR_1,'POF'

Sends power down IR commands 28 (if present) or 9 to the IR_1 device.

PON Turns on a device, based on input Link.

• If at any time the IR sensor reads that the device is off (such as if one turned it off manually at

the front panel), the card automatically attempts to turn the device back on.

• If three attempts fail, card will continue executing commands in the buffer. If there are no

commands in the buffer, the card will continue to try until a 'POF' or 'POD' command is

received.

• If it fails to turn the device on, a PUSH and RELEASE is made on channel 254 to indicate a

power failure error.

• Channel 255 changes are disabled after receipt of this command.

• You can only use the PON and POF commands when an IR device has a linked I/O channel.

Syntax:

SEND_COMMAND <DEV>,'PON'

Example:

SEND_COMMAND IR_1,'PON'

Sends power up IR commands 27 or 9 to the IR_1 port.

PTOF Sets the time between power pulses in .10-second increments, and is stored in permanent

memory.

Syntax:

SEND_COMMAND <DEV>," 'PTOF',<Time>"

Variable:

Time = 0-255 in tenths of a second increments; default = 15 (1.5 seconds).

Example:

SEND_COMMAND IR_1," 'PTOF',15"

Sets the time between power pulses to 1.5 seconds for the IR_1 device.

PTON Sets the duration of power pulses in .10-second increments.

Time is stored in permanent memory.

Syntax:

SEND_COMMAND <DEV>," 'PTON',<Time>"

Variable:

Time = 0-255 in tenths of a second increments; default = 5 (.5 seconds).

Example:

SEND_COMMAND IR_1," 'PTON',15"

Sets the duration of the power pulse to 1.5 seconds for the IR_1 device.

1 2 ... 18 19 20 21 22 23 24 25 26 27 28

Komentáře k této Příručce

Žádné komentáře

AMX NXI Specifikace Strana 23

Komentáře k této Příručce

Související produkty a manuály pro Periferní ovladače AMX NXI