AMX NI-3100 Specifikace stáhnout pdf (Strana 20)

Initial Configuration and Firmware Upgrade

NetLinx Integrated Controllers- WebConsole & Programming Guide (FMv3)

9. Click the Reboot Master button and select Yes to close the Network Addresses dialog.

10. Click Reboot (from the Tools > Reboot the Master Controller dialog) and wait for the System Master to

reboot and retain the newly obtained DHCP Address.

The STATUS and OUTPUT LEDs should begin to alternately blink during the incorporation. Wait until

the STATUS LED is the only LED to blink.

11. Press Done once until the Master Reboot Status field reads *Reboot of System Complete*.

12. Complete the communication process by continuing on to the Communicating Via an IP Address section

on page 10.

Communicating Via an IP Address

Whether the on-board Master’s IP Address was Static Set (via the Set IP Info command) or Dynamically

obtained (via the Get IP Info command), use the IP Address information from the Network Addresses dialog

to establish communication via the LAN-connected Master.

1. Use NetLinx Studio to obtain the IP Address of the NI Controller from your System Administrator.

If you do not have an IP Address:

Follow the steps outlined in either the Obtaining the NI Controller’s IP Address (using

DHCP) section on page 8,

or the Assigning a Static IP to the NI Controller section on page 9.

2. Select Settings > Master Communication Settings from the Main menu to open the Master

Communication Settings dialog (FIG. 9):

3. Click the Communications Settings button to open the Communications Settings dialog (FIG. 10):

Verify that these IP values are also entered into the related fields within either the



IP Settings section of the System Connection page (on the touch panel) or within the

Address field on the web browser.

FIG. 9 NetLinx Studio - Master Communication Settings dialog

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 159 160

Žádné komentáře

AMX NI-3100 Specifikace Strana 20