AMX DESIGN XPRESS V 1.5 - ON SITE INSTALLER GUIDE Instalační příručka Strana 34

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 225
  • Tabulka s obsahem
  • ŘEŠENÍ PROBLÉMŮ
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 33
TIBCO ActiveMatrix BPM Installation and Configuration
22
|
Chapter 2 Pre-install Considerations
Using Third Party Solution
Figure below illustrates the use of third-party solutions to provide highly
available, fault tolerant capabilities to your BPM runtime.
The setup requires at least three machines, say M1, M2, and M3, where:
TIBCO ActiveMatrix BPM (or at least the data folder) is on the shared file
system which is only available to the machine that has a fully operational
TIBCO ActiveMatrix BPM node installed and running.
TIBCO ActiveMatrix BPM and TIBCO ActiveMatrix Administrator are
installed and running on one machine (M1).
The other machines (M2 and M3) are:
connected to a shared file system
a part of an active-passive clustering setup. At any given time, one of the
machines will have access to the shared file system on which the TIBCO
ActiveMatrix BPM Node is installed/running.
In case of any catastrophic event such as power loss, hardware failure,
network disruption, or operating system crash, the cluster software detects
it and fails over to the next available server.
One of these two machines should have a fully operational TIBCO
ActiveMatrix BPM node installed and running.
See Using A Third-Party Solution on page 54 for details on implementing this
scenario.
Zobrazit stránku 33
1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 224 225

Komentáře k této Příručce

Žádné komentáře