AMX AXP-PLV POSITRACK PILOT VIDEO TOUCH PANEL Manuál s instrukcemi stáhnout pdf (Strana 15)

Installation and Wiring

T10-PLV Single Camera Pan/Tilt System

Using the AXlink connector for data and power

To use the AXlink 4-pin connector for data communication with the AXB-EM232 and power

transfer from the PSN6.5 power supply, the incoming PWR and GND cable from the PSN6.5 must

be connected to the AXlink cable connector going to the AXB-PT10. FIG. 11 shows how the power

cable from the PSN6.5 is used to power the AXB-PT10, and the GND cable is connected to the

existing GND cable on the AXlink cable coming from the AXB-EM232. Always use a local power

supply to power the AXB-PT10. This is the configuration of the supplied CC-AXL AXlink

Connection Cable.

Using the camera control RS-232 DB-9 connector

The RS-232 DB-9 (male) connector on the AXB-PT10 connects to the camera head's RS-232

connector. The following table lists the pinouts and shows the pin configuration for the DB-9

connector.

Wiring Information for the AXP-PLV

The AXP-PLV comes with a mini-XLR cable.

Using the AXlink mini-XLR connector for data and power

Wire the Master Controller's AXlink connector to the mini-XLR connector (male) on the rear panel

of the AXP-PLV for data and 12 VDC power as shown in FIG. 12.

FIG. 11 AXlink connector and local +12 VDC power supply wiring diagram

Camera Control DB-9 RS-232 Connector Pinouts

Pin Signal Pin Signal

1N/A6N/A

2RXD7RTS

3TXD8CTS

4N/A9N/A

5GND

PWR+

AXP/TX

AXM/RX

GND-

PWR+

AXP/TX

AXM/RX

GND-

PWR+

GND-

Local +12VDC power supply

(coming from the PSN6.5)

2-pin power connector

Pin 1

Pin 9

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 29 30

Žádné komentáře

AMX AXP-PLV POSITRACK PILOT VIDEO TOUCH PANEL Manuál s instrukcemi Strana 15