AMX AXP-PLV POSITRACK PILOT VIDEO TOUCH PANEL Manuál s instrukcemi

instruction manualCamera Control SystemsPT10-PLVSingle Camera Pan/Tilt System

Installation and Wiring6PT10-PLV Single Camera Pan/Tilt System3. Mount the PosiTrack unit to a flat surface by drilling four holes, according to the m

Installation and Wiring7PT10-PLV Single Camera Pan/Tilt SystemMounting and Balancing the Camera/LensThe camera/lens assembly should be mounted so the

Installation and Wiring8PT10-PLV Single Camera Pan/Tilt System2. Separate the camera mount and cradle support bracket by removing the two ½" scre

Installation and Wiring9PT10-PLV Single Camera Pan/Tilt System10. Remove the camera/lens and mount piece from the support bracket by unscrewing the tw

Installation and Wiring10PT10-PLV Single Camera Pan/Tilt SystemWiring GuidelinesThe PosiTrack Controller requires local +12 VDC power (optional) to op

Installation and Wiring11PT10-PLV Single Camera Pan/Tilt SystemUsing the AXlink connector for data and powerTo use the AXlink 4-pin connector for data

Installation and Wiring12PT10-PLV Single Camera Pan/Tilt SystemWiring Information for the AXB-EM232FIG. 13 shows the front and rear view of the AXB-EM

Installation and Wiring13PT10-PLV Single Camera Pan/Tilt SystemPutting It All Together1. Connect the green 2-pin PS2.8 power connector to the rear of

Installation and Wiring14PT10-PLV Single Camera Pan/Tilt System! AXlink data lines (AXM and AXP) are designed for balance-line operation; wire the dat

Using the AXP-PLV PosiTrack Video Pilot15PT10-PLV Single Camera Pan/Tilt SystemUsing the AXP-PLV PosiTrack Video PilotThe control features of the AXP-

Limited Warranty and DisclaimerAMX Corporation warrants its products to be free from defects in material and workmanship under normal use for a period

Using the AXP-PLV PosiTrack Video Pilot16PT10-PLV Single Camera Pan/Tilt SystemUsing the AXP-PLV Touch Panel ProgramThis section describes the touch p

Using the AXP-PLV PosiTrack Video Pilot17PT10-PLV Single Camera Pan/Tilt SystemPress the NEXT button in the CAMERA page to open the CAMERA MENU page.

Using the AXP-PLV PosiTrack Video Pilot18PT10-PLV Single Camera Pan/Tilt SystemPress the CONFIG button on the CAMERA page to open the CAMERA CONFIGURA

Troubleshooting19PT10-PLV Single Camera Pan/Tilt SystemTroubleshootingIf you are experiencing communication problems with the AXB-EM232, check the com

Troubleshooting20PT10-PLV Single Camera Pan/Tilt System

Sony Technical Support21PT10-PLV Single Camera Pan/Tilt SystemSony Technical SupportOn the WebYou can contact the Technical Assistance Network (TAN) o

Sony Technical Support22PT10-PLV Single Camera Pan/Tilt System

Sony Technical Support25PT10-PLV Single Camera Pan/Tilt System

Table of ContentsiPT10-PLV Single Camera Pan/Tilt SystemTable of ContentsPT10-PLV Single Camera Pan/Tilt System ...

AMX reserves the right to alter specifications without notice at any time.brussels • dallas • los angeles • mexico city • philadelphia • s

iiPT10-PLV Single Camera Pan/Tilt SystemTable of Contents

PT10-PLV Single Camera Pan/Tilt System1PT10-PLV Single Camera Pan/Tilt SystemPT10-PLV Single Camera Pan/Tilt SystemThe AMX Single-Camera Control Syste

PT10-PLV Single Camera Pan/Tilt System2PT10-PLV Single Camera Pan/Tilt SystemPSN6.5 Power SupplyThe PSN6.5 NetLinx Power Supply distributes switched-m

PT10-PLV Single Camera Pan/Tilt System3PT10-PLV Single Camera Pan/Tilt SystemSingle Camera Configuration with CMA-D2 (up to 25 m)FIG. 1 shows a sample

PT10-PLV Single Camera Pan/Tilt System4PT10-PLV Single Camera Pan/Tilt SystemOptional accessories:• WM-CAM Wall or Ceiling Mount Adapter (for AXB-PT10

Installation and Wiring5PT10-PLV Single Camera Pan/Tilt SystemInstallation and WiringThis section covers the steps necessary to connect and operate a