AMX NXT-CV10 Specifikace stáhnout pdf (Strana 34)

CV10 Touch Panel Accessories

10" Modero Touch Panels

Step 2: Install the Compact Flash Memory card upgrade

Discharge any static electricity from your body by touching a grounded metal object and then locate the

existing 64 MB Compact Flash card on the main board (FIG. 21).

2. Insert the tip of a grounded flat-head screwdriver into one of the card removal grooves (located on either

side of the existing card), and gently pry the card out of the slot (FIG. 22). Repeat this process on the

opposite card removal groove. This alternating action causes the card to "wiggle" away from the on-board

connector pins.

3. Grip the old card by its sides and then carefully pull it out of the slot.

4. Remove the new CF memory card from it’s anti-static bag.

5. Firmly grip the sides of the new CF memory card and insert it firmly into slot opening (with the arrow

facing towards the pins) until the contact pins are completely inside the flash card and it is then securely

attached to the pin sockets.

6. To complete the upgrade process, either upgrade the remaining wireless card (Step 3) or close and re-

secure the enclosure using the procedures in Step 4: Close and Resecure the NXT Panel Enclosure section

on page 24.

FIG. 21 Location and orientation of the card slots (both CV10 panels)

FIG. 22 Removing/installing a Compact Flash Memory card

Compact Flash

Memory Card (Slot 1)

Wireless CF Card

(Slot 2)

Card removal grooves

Card Removal Grooves

Front of panel

Tilt Bracket cover plate

Card removal grooves

Insert with arrow

facing towards the pins

On-board Compact

Flash connector (with pins)

Connector opening

Any new internal card upgrade is detected by the panel only after power is cycled.

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 207 208

Žádné komentáře

AMX NXT-CV10 Specifikace Strana 34