AMX RMS CODECRAFTER Instalační příručka stáhnout pdf (Strana 36)

RMS Server Configuration

RMS Enterprise - Installation Guide

3. Enter specific file path information for each file type if necessary (click the Browse buttons to navigate to

the desired directories in the Choose Your Directory dialog). However, in most cases, the default directory

settings should be used.

4. Click Next to proceed to the Legacy Configuration dialog (FIG. 25).

Legacy Configuration refers to the process of configuring existing NetLinx Masters running RMS v3.x

(or earlier) code for use with RMS Enterprise servers.

Note that by default, Legacy Support is disabled (as indicated by the un-checked Enable Legacy Support

option in the upper-right corner of the dialog). The options in this dialog are only available if the Enable

Legacy Support option is selected (as shown above).

If you are not planning to use NetLinx Masters running RMS v3.x (or earlier) code with RMS Enterprise

servers, leave this option de-selected, and click Next to proceed.

If you are migrating to RMS Enterprise from a previous version of the RMS SDK, either fill in these

fields, or accept the default values:

FIG. 25 RMS Server Configuration tool - Legacy Configuration dialog

Throughout the dialogs in the RMS Server Configuration tool, any required fields that

are not filled in are indicated with red shading.

Legacy Configuration Options

• Legacy IP

Address

This field identifies the IP address of the RMS Enterprise server.

Note: This value should only be changed if there are multiple NIC cards in the RMS

Enterprise Server (as in a multi-server installation).

Default = 0.0.0.0

• Legacy Port This field identifies the IP port on which the Legacy (v3.x) RMS server accepts

connections from legacy NetLinx masters.

Default = 3839 (this is an IANA registered port for Legacy (v3.x) RMS

communications).

• Ping Delay The Ping Delay setting is used to ensure that NetLinx clients are connected to the

RMS server. On this configured time interval, the RMS server broadcasts request

messages to the NetLinx clients.

If the NetLinx clients do not respond within a specified amount of time, the RMS server

assumes the connection has been lost and the NetLinx system is offline.

Default = 30 (seconds)

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 135 136

Žádné komentáře

AMX RMS CODECRAFTER Instalační příručka Strana 36