AMX OLDesign Manuál s instrukcemi Strana 1

instruction manualWired Control PanelsSP+ Softwire PanelsAXU/AXM-SP+

Installation6SP+ Softwire Panels3. Set the DIP switches for the AXlink device code assigned to the unit. The device code number is a function of the s

Installation7SP+ Softwire Panels6. Snap engraved faceplate into magnetic bezel.7. Set the DIP switches for the AXlink device code assigned to the unit

Installation8SP+ Softwire PanelsAXM-SP+ (rack mount)Mount the AXM-SP+ rack-mount panels into a standard 19" equipment rack, as shown in FIG. 9.

Installation9SP+ Softwire Panels2. Set the DIP switches for the AXlink device code assigned to the unit (refer to Setting the AXlink Device Number on

Installation10SP+ Softwire Panels

Programming11SP+ Softwire PanelsProgrammingPushbutton ProgrammingPushbuttons are individually programmable and can be used in any combination as singl

Programming12SP+ Softwire PanelsFor example:DEFINE_DEVICEVOL = 12 (* VOLUME CONTROL CARD DEVICE 12 *)MSP = 128

Programming13SP+ Softwire Panels! Bar (PWR) Default programming mode; all LEDs from the bottom up to the display level are lit.! Dot Mode Only t

AMX reserves the right to alter specifications without notice at any time.brussels • dallas • los angeles • mexico city • philadelphia • s

AMX Limited Warranty and DisclaimerAMX Corporation warrants its products to be free of defects in material and workmanship under normal use for three

Table of ContentsiSP+ Softwire PanelsTable of ContentsProduct Information ...

iiSP+ Softwire PanelsTable of Contents

Product Information1SP+ Softwire PanelsProduct InformationThe AMX SP+ Softwire Panels are microprocessor-controlled pushbutton display units that can

Product Information2SP+ Softwire PanelsFront Panel ControlsSoftwire Panel pushbuttons can be programmed individually or in any combination as a single

Installation3SP+ Softwire PanelsInstallationSetting the AXlink Device NumberSet AXU-SP+ device number before wiring AXlink. The AXU-SP+ can be assigne

Installation4SP+ Softwire Panelsallowable between the Softwire Panel and control system. The maximum wiring lengths for using AXlink power are based o

Installation5SP+ Softwire PanelsMounting the SP+ PanelsThe following paragraphs describe how to mount the UniMount, wood enclosed, and rack-mount Soft