AMX MVP-5150 Specifikace stáhnout pdf (Strana 33)

Accessories

MVP-5100/5150 5.2" Modero Viewpoint Touch Panels

Other MVP-WCS-52 installations

The Wall-Mounted Charging Station is designed to be installed in various different locations, such as

into the face of a wooden podium or the top of a table. Depending upon the ability to wire it to a power

source, Wall-Mounted Charging Stations may be installed on vertical or horizontal surfaces composed of

such materials as wood, brick, and glass.

Installing a Wall-Mounted Charging Station into a solid wall thicker than a standard thickness of

sheetrock is possible, but requires special preparation. If installing into a solid wall of concrete or rock, a

recess must be chiselled or cut out to match the size of the device. The box is sized 8.375 inches

(21.27cm) long and 5.75 inches (14.60cm) high, so the hole should be at least 1/4" (0.64cm) smaller in

these dimensions. To facilitate the full range of movement of the device’s components, the recess must

be at least 2.69 inches (6.83cm) deep.

Ensure that the power cable has been installed in the wall and is accessible by the

installer before chiseling out the recess.

Instead of using the lockdown wings to secure the Plastic Back Box, standard

concrete screws may be inserted through the screw holes after removing the

lockdown wings. However, drill the concrete screw holes into the wall before setting

the screws into the box, as excessive torque applied to the screws will damage the

box. To avoid this, the box may be installed with adhesive. Test an unobtrusive spot

on the back of the box with a sample of the adhesive to check for any adverse

reactions before installing the device.

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 189 190

Žádné komentáře

AMX MVP-5150 Specifikace Strana 33