AMX NetLinx NXB-KNX Manuál s instrukcemi stáhnout pdf (Strana 10)

Installation

NXB-KNX KNX Communications Gateway

PoE (Power Over Ethernet)

The NXB-KNX uses CAT5/CAT6 wire via the Ethernet port for PoE power.

Use the PS-POE-AF Power over Ethernet Injector (FG423-80) to simplify wiring and installation by eliminating the

need for an AC outlet at each point of installation.

If used with a non PoE-capable Ethernet switch (such as the NXA-ENET24), then an optional PS-POE-AF

Power-over-Ethernet (PoE) power supply is required to provide power to the NXB-KNX.

If the NXB-KNX is used with a PoE-capable Ethernet switch (such as the NXA-ENET24PoE), then no PoE

Injectors are required.

KNX Connector

The KNX connector on the rear panel is a 2-pin captive-wire connector (optically isolated) that provides communication

between the NXB-KNX and the KNX control system via 2-wire shielded twisted pair cabling (FIG. 4).

The NXB-KNX can be placed up to approximately 330’ (100 meters) from PoE

Injector.

FIG. 4 KNX Connector wiring diagram

KNX

Control

Bus

2-wire twisted pair

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 63 64

Žádné komentáře

AMX NetLinx NXB-KNX Manuál s instrukcemi Strana 10